How To Apply Wood Filler To Log Siding

Make sure you install the foundation log along the bottom of the wall.

How to apply wood filler to log siding. Apply the filler to the craft sticks using another craft stick or a putty knife. 6 then using a putty knife shaped piece of wood or a finger tool the bead to further force the sealant into intimate log contact. Cut and install the foundation log. Now use a two part epoxy based wood filler to fill the holes.

Squeeze the filler into the hole. Subscribe to this old house. Scrape all loose paint from around the area to be repaired using a paint scraper or putty knife. The filler should be level and even with the surface of the wood.

Dig out all the rot from inside the crack or hole with an awl or a flat head screwdriver. The best substances for plugging holes and filling cracks with this old house general contractor tom silva. Fill the crack completely then scrape the excess from the. Mix it first according to the instructions on the container.

Use the tube to squeeze the filler into the area making sure to fill in the deepest area by pressing the end down into it. Apply epoxy wood filler with a putty knife as an alternative to using caulk. Sand the edges of the. Start at one end and gradually work your way to the other end.

Overfill slightly to allow for the fact that the filler. Attach the log sidings to your studs using the 3 inch lag screws. These epoxy fillers set up fast so only mix what you can use within 15 minutes. The craft sticks will act as a support for the wood filler.

It s important to get all. Once your wood filler is mixed use it quickly. It is best to fill in two or three steps rather than try to fill a deep hole in one pass. Apply the wood filler using a putty knife.

While tooling scrape the excess sealant from the sharp edges of the check and remove any material that may have smeared over the surfaces of the adjoining logs with a wet rag or sponge. After they dry they can be sanded molded painted or stained to match your existing log siding. Start at the edge of the damaged area pressing the wood filler into the depression. If you don t have a tube use a putty knife to apply it.