How To Build A Lean To Shed Roof Step By Step

Building lean to roof.

How to build a lean to shed roof step by step. Assemble the door frame with 2 1 2 pocket screws and then attach the t1 11 siding panel with glue and nails. Align the edges flush and insert 2 1 2 screws to secure the jambs into place tightly. Next bolt the 2x8 joist carrier onto the posts using the 4 x 5 16 lag screws. After filling in the holes with dirt be sure to square and level the posts in their holes.

Use 6 8d nails every 8 along the framing. Fit the 1 8 trims to the sides of the shed. Measure the width of the outside wall and cut the board with a circular saw to the same length. Align the edges flush and insert 1 5 8 screws every 8 along the rafters.

Roof sheets 10 10 lean to shed. Cut and fit the 1 2 plywood sheets to the top of the shed roof. Fitting the jambs 10 14 lean to shed. That means for every 12 inches or foot the roof runs.

First bolt 4 16ft long 2 6 stringers to the side of your structure. Attach the 2 4 jambs around the door opening. Use a 2 by 4 inch board for a short roof up to about 8 feet a 2 by 6 for a longer one. I live in a snowy climate and the lean to roof slope gave me some concerns.

Align the edges flush and insert 1 5 8 screws every 8 along the rafters. The steeper the slope the faster it sheds snow ice and leaves so less build up. Use 6 x 5 16 lag screws recessed into the wood. Fitting the double doors.

It goes up 5 inches. Roof sheets 8 10 shed with lean to roof. Step 1 make a ledger board to fasten to the existing wall and support the upper end of the lean to roof.