How To Build A Walkway In The Attic

We install the elevated walkway so that the insulation does not get compressed and so that the home has a consistent amount of insulation throughout the attic.

How to build a walkway in the attic. The surface itself just has to be strong enough to handle your weight along with tools and gear. These gussets should run from the bottom of the chord to. We normally recommend that you place plywood over the top of the rafters creating a walkway to the a c and in that area only lay in one or two layers of unfaced fiberglass blanket on top of the plywood walkway and around the ac unit itself. Step 3 selecting the lumber.

Step 2 taking measurements. Step 4 cutting the wood. Step 5 pattern of the floor. The attic walkway is constructed so that sits above the horizontal chords of your attic.

The lumber should be wide enough to extend above. Pour at least two to three inches of crushed gravel over the compacted ground. How to make a catwalk in the attic. We used leftover plywood scraps to build ours an attic walkway also needs enough support.

This is because the. Cut either 2 by 4 inch or 2 by 6 inch lumber into lengths that match the width of the plywood. Use a landscape rake to spread it out evenly. Step 1 planning the layout.

Ideas for creating your attic walkway. The intent is to lay down the boards and the ends should attach to a ceiling rafter. Remember work in sections so you can adjust the walkway as needed.